User's Guide
Table Of Contents
- STORE OPERATIONS MANUAL
- Table of Contents
- SET UP
- DESIGINING A STAMP
- Overview
- Stampcreator P-touch Editor
- Tools for Formatting
- Formatting a Stamp
- Selecting the stamp size
- Typing text
- Changing the font
- Changing the character size
- Changing style effects
- Changing the font of a text block
- Changing the character size of a text block
- Centering text within a block
- Vertical and horizontal block alignment
- Drawing lines in a stamp
- Drawing a frame
- Changing the frame size
- Using special design frames
- Creating stamps with clip art images
- Creating stamps with pictures
- Advanced Steps
- Stampcreator Express
- MAKING A STAMP
- CARE & TROUBLESHOOTING
- SUPPLIES & ACCESSORIES
- SUPPORT NUMBERS
- brother ENG
43
MAKING A STAMP
Making an ID label
After engraving the stamp, we can print the same layout on a label that can
be attached to the stamp for easy identification. In order to see how the
stamp will appear when it is engraved, the ID label can be printed before
engraving the stamp.
a Insert an ID label sheet, so that the words “ID LABEL” can be read,
straight into the narrow ID label slot to the right of the draft tray slot.
☞ NOTE: Be careful not to touch the print area of the ID
label sheet since dust, fingerprints, hand
creams, etc. may prevent the characters from
being printed correctly.
Be sure that the ID label is the correct size.
Do not use an ID label that has been folded.
• ID labels for smaller size stamps (1212, 2020, 3030, 4040, 1060, and
1438) have two printing areas on each label. Print labels in the lower
portion first, and then save the unused portion for future use. The
machine will always print on the lower portion.
b With the layout of the engraved stamp displayed in Stampcreator
P-touch Editor, select the Print command in the File menu.
Or click in the Print Properties. The Print dialog box appears.
c Select “ID Label”, and then select the appropriate setting in the
“Document Type” drop-down list.
Insert an ID label sheet into the ID label slot of the SC-2000USB, and
then click the Print button to start printing the ID label.
☞ NOTE: For details on printing an ID label with
Stampcreator Express, refer to page 35.
• The ID label will automatically be fed from the slot on the top at the
right end of the machine.
Applying an ID label
After the label has been printed and fed from the exit slot on the top at the
right end of the SC-2000USB, remove it, peel off the ID label from its
backing paper, and then affix the ID label to the top of the grip.
☞ NOTE: Some stamps, such as the 4090, 3458, and
4040, have an L-shaped ID label. When
attaching this type of ID label, apply the short
side first, and then apply the remaining side
to the stamp grip.
ID label slot
ID label
Grip