User's Guide
Table Of Contents
- STORE OPERATIONS MANUAL
- Table of Contents
- SET UP
- DESIGINING A STAMP
- Overview
- Stampcreator P-touch Editor
- Tools for Formatting
- Formatting a Stamp
- Selecting the stamp size
- Typing text
- Changing the font
- Changing the character size
- Changing style effects
- Changing the font of a text block
- Changing the character size of a text block
- Centering text within a block
- Vertical and horizontal block alignment
- Drawing lines in a stamp
- Drawing a frame
- Changing the frame size
- Using special design frames
- Creating stamps with clip art images
- Creating stamps with pictures
- Advanced Steps
- Stampcreator Express
- MAKING A STAMP
- CARE & TROUBLESHOOTING
- SUPPLIES & ACCESSORIES
- SUPPORT NUMBERS
- brother ENG
38
MAKING A STAMP
Final Steps
Getting ready
a Start up Stampcreator P-touch Editor.
For details on using the Stampcreator Express software, refer to pages 33
through 34.
b Make sure that “SC-2000USB” is selected as the printer in the Printer
Setup dialog box (Printer/Page Setup command in the File menu of the
software).
c Design a stamp.
☞ NOTE: You cannot reprint or reuse a stamp once it
has already been used. Before printing, open
the stamp shutter to make sure that you are
using the correct draft sheet.
Dust may cause poor printing and engraving.
Make sure that there is no dust on the
printing side of the stamp before inserting the
stamp into the machine.
Printing a draft sheet
a Load a draft sheet into the machine to print a positive image.
Fully insert the draft sheet magazine tray straight into the draft sheet
magazine tray slot.
☞ Be careful not to pinch your fingers while inserting the draft sheet
magazine tray.
To remove the draft sheet magazine tray, grab its outer case, and
then pull out the entire magazine tray.
b Turn on the machine.
c Make sure the message “READY” appears in the LCD.
d Click to display the Print Properties. (If they are already
displayed, skip this step.)
Click in the Print Properties to display the Printer Setup dialog
box.
e Check that “Brother SC-2000USB” is selected below “Application
Matching Printer”, and then click the OK button.
Click in the Print Properties. The Print dialog box appears.
Draft sheet magazine tray
Draft sheet magazine
tray slot
MAKING A STAMP