User's Guide
Table Of Contents
- STORE OPERATIONS MANUAL
- Table of Contents
- SET UP
- DESIGINING A STAMP
- Overview
- Stampcreator P-touch Editor
- Tools for Formatting
- Formatting a Stamp
- Selecting the stamp size
- Typing text
- Changing the font
- Changing the character size
- Changing style effects
- Changing the font of a text block
- Changing the character size of a text block
- Centering text within a block
- Vertical and horizontal block alignment
- Drawing lines in a stamp
- Drawing a frame
- Changing the frame size
- Using special design frames
- Creating stamps with clip art images
- Creating stamps with pictures
- Advanced Steps
- Stampcreator Express
- MAKING A STAMP
- CARE & TROUBLESHOOTING
- SUPPLIES & ACCESSORIES
- SUPPORT NUMBERS
- brother ENG
12
SET UP
First Steps
After you have designed a stamp layout using the Stampcreator P-touch Editor software or Stampcreator Express software,
you can engrave it into a stamp.
Installing the ink ribbon cassette
a Press the ink ribbon compartment cover button to open the cover.
☞ NOTE: Open and close the ink ribbon compartment
cover by pressing only on the position
specified.
b If the ink ribbon in the cassette is loose, turn it over and use your finger
to wind the toothed wheel on the large knob on the right side until
there is no slack in the ribbon.
c Insert the knobs on the left end of the cassette into the slots on the left
side of the compartment, and then push down on the right end of the
cassette so that the knobs on the right side slide into the slots on the
right side of the compartment.
d Slowly close the ink ribbon compartment cover so that it locks into
place.
☞ NOTE: Be careful not to pinch your fingers with the
compartment cover while closing it.
Replacing a used ink ribbon cassette
a Remove the empty cassette by pulling it straight up.
b Follow the instructions described above to insert the new ink ribbon
cassette.
☞ NOTE: One ink ribbon cassette will yield
approximately 150 stamps and ID labels. The
message “CHECK RIBBON” will appear on
the Stampcreator Pro’s LCD when the
cartridge is empty. To order more ink ribbon
cassettes, see page 57.
Ink ribbon
cassette
Slots
Ink ribbon compartment