User's Guide
Table Of Contents
- STORE OPERATIONS MANUAL
- Table of Contents
- SET UP
- DESIGINING A STAMP
- Overview
- Stampcreator P-touch Editor
- Tools for Formatting
- Formatting a Stamp
- Selecting the stamp size
- Typing text
- Changing the font
- Changing the character size
- Changing style effects
- Changing the font of a text block
- Changing the character size of a text block
- Centering text within a block
- Vertical and horizontal block alignment
- Drawing lines in a stamp
- Drawing a frame
- Changing the frame size
- Using special design frames
- Creating stamps with clip art images
- Creating stamps with pictures
- Advanced Steps
- Stampcreator Express
- MAKING A STAMP
- CARE & TROUBLESHOOTING
- SUPPLIES & ACCESSORIES
- SUPPORT NUMBERS
- brother ENG
6
SET UP
Connecting the Interface and Power Supply Cables
After connecting the interface and power supply cables to the SC-2000USB, it can be used to create stamps from any layout
that you design in the Stampcreator P-touch Editor software or Stampcreator Express software installed on your computer.
a Be sure both the SC-2000USB and the computer are turned off.
b Attach the appropriate interface cable connector to the computer port.
☞ NOTE: After connecting the 9-pin connector, be sure to tighten the screws to lock it into
place.
c Connect the other end of the interface cable to the interface jack on the back of the SC-2000USB.
d Insert one end of the power supply cord into the power supply jack on the SC-2000USB and the other end of the cord
into an AC outlet.
System Requirements
Computer Requirements
Check that your system meets the following requirements.
• OS: Windows
®
XP / Windows Vista
®*1
/ Windows
®
7
*1
• Interface: USB port (USB Spec 1.1 or 2.0 protocol)
COM port (9-pin RS-232C serial port that supports 115,200 bps)
• Hard Drive: Over 70MB of available space
*2
• Memory: Windows
®
XP: 128 MB or more
*2
Windows Vista
®
: 512 MB or more
*2
Windows
®
7: 1 GB (32-bit) or 2 GB (64-bit) or more
• Monitor: SVGA, high color or higher graphics card
• Others: CD-ROM drive, pointing device
*1 The computer should meet Microsoft
®
’s recommendations for the OS installed.
*2 Required available space when installing the software with all of the options.
9-pin connector
9-pin connector
USB connector
USB connector jack
Power switch
Power supply jack
8-pin connector jack
8-pin connector
USB connector
Back: