Raster Command Reference

- 28 -

4. Printing Command Details

ESC i a Switch dynamic command mode

ASCII: ESC i a {n1}

Hexadecimal: 1B 69 61 {n1}

Parameters

Definitions of {n}:

0: ESC/P mode (default of QL-710W / QL-720NW) (QL-710W / QL-720NW Only)

1: Raster mode (Be sure to switch to this mode.) (default of QL-600)

3: P-touch Template mode (QL-710W / QL-720NW Only)

FF: Mode set as default

Description

⚫ Dynamically switches between the printer's command modes. A printer that receives this command

operates in the specified command mode until the printer is turned off.

⚫ The printer must be switched to raster mode before raster data is sent to it. Therefore, send this command

to switch the printer to raster mode.

g Raster graphics transfer

ASCII: g {s} {n} {d1} ... {dn}

Hexadecimal: 67 {s} {n} {d1} ... {dn}

Parameters

{s} 00h

{n} Number of bytes of raster data (d1 to dh)

However, use the following value if no compression is specified as the compression mode.

n=104

{d1~dn} Raster data.