Raster Command Reference

- 31 -

4. Printing Command Details

ESC i a Switch dynamic command mode

ASCII: ESC i a {n1}

Hexadecimal: 1B 69 61 {n1}

Parameters

Definitions of {n1}:

0: ESC/P mode

1: Raster mode (Be sure to switch to this mode.)

3: P-touch Template mode

Description

⚫ Dynamically switches between the printer's command modes. A printer that receives this command

operates in the specified command mode until the printer is turned off.

⚫ The printer must be switched to raster mode before raster data is sent to it. Therefore, send this command

to switch the printer to raster mode.

⚫ The PT-P710BT does not support ESC/P mode and P-touch Template mode.

ESC i ! Switch automatic status notification mode

ASCII: ESC i ! {n1}

Hexadecimal: 1B 69 21 {n1}

Parameters

Definitions of {n1}

0：Notify. (default)

1：Do not notify.

Description

⚫ Dynamically switches whether the automatic status notification is given during printing. A printer that

receives this command operates in the specified command mode until the printer is turned off.

⚫ Use this command when building a system where the status is not obtained using a status information

request.