Raster Command Reference

Raster Command Reference
- 12 -
2. Print Data
Descriptions for the numbers in the print data on the previous page are provided in the following table.
For details on each command, refer to “4. Printing Command Details”.
No.
Command Name
Description
１
Invalidate
A 100-byte invalidate command is sent.
2
Initialize
The “initialize” command is sent.
3
Switch dynamic
command mode
The printer is switched to raster mode.
Send this command before sending raster data to the printer.
4
Job ID setting
commands
Internal specification commands
Since this is a command for outputting with the commercial
version driver, it is unnecessary for the user to send this
command.
5
Print information
command
Media size information for the print data is sent.
This is the command for “24 mm” tape.
6
Various mode settings
(1Bh+69h+4Dh+00H)
This is a command for specifying a mode.
Here, nothing is specified.
7
Specify the page
number in “cut each *
labels”
The number of pages printed before automatically cutting is
specified.
8
Advanced mode
settings
This is the command for specifying settings for the advanced
mode.
9
Specify margin amount
Specifies the amount of the margins.
This is the command for “15 dots”.
10
Select compression
mode
TIFF compression mode is selected.
11
Raster data
Raster data continues.
12
Print command
Since it is not the last page, the print command is sent at the end
of the page.
13
Print command with
feeding
Since it is the last page, the print command with feeding is sent at
the end of the page.
14
Switch automatic
status notification
mode
Dynamically switches whether an automatic status notification is
given during printing.