Datasheet
How to make a stamp
Stampcreator
®
will enable you to impose images onto rubber stamp surfaces. After
you create the image on your computer and insert the text, the rest of the process
will take just a few minutes. Ink never touches your fingers...this dry process is
absolutely clean.
1. Start the Stamp Editor
program on your PC and then
create any image you wish.
2. The Stampcreator
®
PRO
System will instantly transfer
the image you have prepared
on your computer screen onto
a transparent film, which will
be loaded automatically from
the magazine tray inside.
600 dpi thermal transfer
printing will reproduce every
detail from your graphics.
Open the window and you will
see the film (positive master)
for your stamp positioned
above the Xenon Flash
Assembly.
3. Position a blank stamp in the
stamp creation bay above the
Xenon ash assembly.
4. When the door to the stamp
creation bay is shut, the Xenon
ash is automatically triggered.
5. The surface of the stamp is made of a light sensitive rubber
material specially developed for the Brother Stampcreator
®
PRO
System. Light from the Xenon ash causes millions of micro-
pores in the stamp surface to close. Only pores protected by
the black printing on the positive master film will
remain open.
6. Attaching the stamp handle causes the ink pack embedded
in the stamper base to open. Keep the stamp upright for a
few minutes for all the ink to absorb. After a brief “Cure Time,”
the ink is absorbed by the stamp material and will be ready
to use. An ID label can be printed in the same way by the
Stampcreator
®
PRO System.
You can print a label and proof read it before the
final stamp is made. Then the entire stamp message
can be clearly displayed on the top for positive
identification.
The ink pack is built into the stamper base and attaching
the handle causes it to open. It’s absolutely safe and clean,
non-toxic and non-flammable.
The long lasting ink tank is not directly exposed to air. Tiny
micro paths protect it so it won’t dry up like conventional
stamps... even if you leave the bottom cap off.
The specially developed ink dries in seconds
on regular or coated paper
The rubber surface has millions of micro-pores
that permit just the right amount of ink to come
through. This makes it possible to put very
precise graphics on the stamp.
Error-free ID Label
No messy ink pads
Laser sharp image
Virtually smudge-proof
Long lasting
1 2
3 4
5 6