P-touch Template Manual/ Command Reference
Table Of Contents
- P-touch Template Manual
- P-touch Template Command Reference
- Control Code List
- About P-touch Template
- Static and dynamic commands
- If printing does not begin (main most frequent causes)
- Control Command Details
- ^PT Specify print start trigger selection
- ^PS Specify print start command text string
- ^PC Specify print start received character count
- ^SS Specify delimiter
- ^TS Specify template selection
- ^LS Specify line spacing with line return
- ^CC Change the prefix character
- ^RC Specify line return command text string
- ^CN Specify number of copies
- ^II Initialize
- ^SR Status request
- ^VR Retrieve version Information
- ^CR Line return in object
- ^OS Specify object selection (object number)
- ^ON Specify object selection (object name)
- ^DI Direct object insertion
- ESC ia Specify command mode
- ESC iXT2 Specify print start trigger selection
- ESC iXP2 Specify print start command text string
- ESC iXr2 Specify print start received character count
- ESC iXD2 Specify delimiter
- ESC iXa2 Specify Non-Printed character text strings
- ESC iXi2 Specify command mode
- ESC iXn2 Specify template selection
- ESC iXf2 Change the prefix character
- ESC iXm2 Select character code set
- ESC iXj2 Specify international character set
- ESC iXR2 Specify line return command text string
- ESC iXC2 Specify number of copies
- ESC iXT1 Retrieve select print start trigger items
- ESC iXP1 Retrieve print start command setting text string
- ESC iXr1 Retrieve print start received character count
- ESC iXD1 Retrieve delimiter
- ESC iXa1 Retrieve Non-Printed character text strings
- ESC iXi1 Retrieve command mode setting
- ESC iXn1 Retrieve template selection number
- ESC iXm1 Retrieve character code set
- ESC iXj1 Retrieve international character set setting
- ESC iXf1 Retrieve the prefix character
- ESC iXR1 Retrieve line return command setting text string
- ESC iXC1 Retrieve number of copies
- Character code
- International character set table
19
Precautions
Static commands
Static commands are valid only in the following modes;
MW-145BT/MW-260
： raster mode
PJ-623/PJ-663
： maintenance mode
Example: To statically change the template selection number to 10
1) Switch to maintenance mode.
ESC i a 01h (1Bh 69h 61h 01h)
2) Select template number 10.
ESC i X n 2 01h 00h 0Ah
(1Bh 69h 58h 6Eh 32h 01h 00h 0Ah)
3) Dynamically enter the P-touch Template mode.
ESC i a 03h (1Bh 69h 61h 03h)
Notes for using Bluetooth (only MW-145BT/MW-260/PJ-663)
When you are connecting the
printer via Bluetooth, the printer may not start to receive the
data immediately after the port is opened. We advise to wait for an interval of 500 msec
before sending the print data to the
printer.
If you normally close and re-open the Bluetooth port between prints, we would again advise
to leave 500 msec between the port being closed and re-opened.
Also, once you have sent the print data, and the printing process has begun, do not close
the port. Please ensure 32 bytes of data has been received by the printer, and then close
the port.