P-touch Template Manual/ Command Reference
Table Of Contents
- P-touch Template Manual
- P-touch Template Command Reference
- Control Code List
- About P-touch Template
- Static and dynamic commands
- If printing does not begin (main most frequent causes)
- Control Command Details
- ^PT Specify print start trigger selection
- ^PS Specify print start command text string
- ^PC Specify print start received character count
- ^SS Specify delimiter
- ^TS Specify template selection
- ^LS Specify line spacing with line return
- ^CC Change the prefix character
- ^RC Specify line return command text string
- ^CN Specify number of copies
- ^II Initialize
- ^SR Status request
- ^VR Retrieve version Information
- ^CR Line return in object
- ^OS Specify object selection (object number)
- ^ON Specify object selection (object name)
- ^DI Direct object insertion
- ESC ia Specify command mode
- ESC iXT2 Specify print start trigger selection
- ESC iXP2 Specify print start command text string
- ESC iXr2 Specify print start received character count
- ESC iXD2 Specify delimiter
- ESC iXa2 Specify Non-Printed character text strings
- ESC iXi2 Specify command mode
- ESC iXn2 Specify template selection
- ESC iXf2 Change the prefix character
- ESC iXm2 Select character code set
- ESC iXj2 Specify international character set
- ESC iXR2 Specify line return command text string
- ESC iXC2 Specify number of copies
- ESC iXT1 Retrieve select print start trigger items
- ESC iXP1 Retrieve print start command setting text string
- ESC iXr1 Retrieve print start received character count
- ESC iXD1 Retrieve delimiter
- ESC iXa1 Retrieve Non-Printed character text strings
- ESC iXi1 Retrieve command mode setting
- ESC iXn1 Retrieve template selection number
- ESC iXm1 Retrieve character code set
- ESC iXj1 Retrieve international character set setting
- ESC iXf1 Retrieve the prefix character
- ESC iXR1 Retrieve line return command setting text string
- ESC iXC1 Retrieve number of copies
- Character code
- International character set table
17
■ Others
· A maximum of 99 templates can be transferred. The transfer cannot be completed if the
amount of data being transferred exceeds the followings;
MW-145BT/MW-260 ： 512KB
PJ-623/PJ-663 ： 5,888KB
· A single template can contain at the maximum the following numbers of objects. When
trying to transfer more objects than the maximum, an error will occur and the transfer
cannot be completed.
MW-145BT/MW-260
： 50 objects
PJ-623/PJ-663
： 200 objects
· A single template can contain a total of 1000 lines of text. If it exceeds this limit, an error
will occur during printing.
· The line return codes (0D0A, 0D and 0A) in print data are read, then discarded. However,
when specified as special data, such as delimiters or print start text strings or line return
commands, they are applied.
· The order of the objects is determined only by the last four-digit number of the object name.
Objects with no numbers in their names will be at the end of the order. If objects have the
same number, the order is determined in the following order: text, 1D bar codes, then 2D
bar codes. If the objects are of the same type, the object created first is first in the order.
We recommend that the numbers indicating the order be added at the end of the object
name.
(To specify the name of an object in P-touch Editor, display the properties of the text or bar
code object, and then specify the name in the “Object Name” box on the Expanded tab.)
Specifying the object name