Startup : Reference Guide

7
Installation
Installation Procedure
This section describes how to install the application software.
a
• Before beginning the installation, follow the procedure below to back up the installer onto your computer.
1) Create a backup folder on the computer.
2) Copy the entire [PE-DESIGN 11] folder from the “PE-DESIGN Software Key” into the folder created in
step 1).
• Do not delete the data in the [PE-DESIGN 11] folder on the “PE-DESIGN Software Key”.
1 Plug the "PE-DESIGN Software Key"
into the USB port on the computer.
 After a short while, the [AutoPlay]
dialog box automatically appears.
 For Windows 7 users, follow step 3
after the [AutoPlay] dialog
appears.
a
Do not unplug or plug in the "PE-DESIGN Software Key" until the installation is completed.
b
If the [AutoPlay] dialog does not automatically start up:
• For Windows 10/8.1 users:
1) Right-click / and select [Run] in the command list.
* For Windows 8.1, move the pointer over the lower-left corner of the screen to show , and right-
click .
 The [Run] dialog box appears.
2) Type in the full path to the installer, and then click [OK] to start up the installer.
For example: E:\PE-DESIGN 11\setup.exe (where "E:" is the drive name used for "PE-DESIGN
Software Key")
• For Windows 7 users:
Click , then [All Programs]. Select [Accessories] and then click [Run] to display the [Run] dialog
box. Type in the full path to the installer in the input window.