Label Printer Quick Reference
Table Of Contents
- PT9500PC_Ca-E_Ca-Fr.pdf
- English
- Introduction
- Table of Contents
- 1 Before use
- 2 Installing the software
- 3 Creating labels: Windows version
- 4 Creating labels: Macintosh version
- 5 Appendix
- French
- Introduction
- Table des matières
- 1 Avant l'utilisation de l'imprimante
- 2 Installation du logiciel
- Types de logiciels utilisés
- Sous Windows
- Précautions relatives à l'installation
- Installation de base
- Installation du logiciel P-touch Editor uniquement
- Installation du logiciel P-touch Quick Editor uniquement
- Installation du pilote d'imprimante uniquement
- Réglage de la vitesse de transmission du PC et de la PT-9500PC
- Désinstallation du logiciel
- L'imprimante n'est plus utilisée
- Sous Mac OS 8.6-9.x
- Sous Mac OS X 10.1 ou version ultérieure
- 3 Création d'étiquettes : version Windows
- 4 Création d'étiquettes : version Macintosh
- 5 Annexes
- English
21
Before use
3
Check the tape cassette.
Make sure that the end of the tape is not
bent and that it is routed correctly through
the tape guides.
4
Install the tape cassette.
Be sure to install the tape cassette in the
correct direction.
5
Close the tape compartment cover.
6
Press the power button on the
PT-9500PC.
→
The power button will light (green).
• If the tape compartment cover is not
completely closed or if the tape cassette
is not installed correctly, the ERROR
lamp will light. In this case, repeat the
procedure from step
2
.
7
Press the feed/cut button.
→
Remove the tape slack.
Tape guides
End of the tape
Note
● If no additional operation is performed
within 10 minutes after printing a label,
the roller holder will automatically
release and a sound may be produced.
Due to this function, the tape cannot be
removed if the AC adapter is removed
from the PT-9500PC with the PT-9500PC
turned on because the roller holder will
not be released. Always turn off the
PT-9500PC before removing the AC
adapter from the PT-9500PC.
Power button
Feed/cut button