Label Printer Quick Reference

13
Before use
Lamp display
The condition of the PT-9500PC can be determined by the power button lamp (green) and the ERROR
lamp (red).
Lamp condition
Condition Remedy
Power button
(green)
ERROR lamp
(red)
Lit Not lit
PT-9500PC standby
condition
—
Flashing Not lit Receiving data —
Flashing Lit
Receiving data
No tape cassette
Install the tape cassette and close the
tape compartment cover.
Receiving data
Tape compartment cover is
open.
Close the cover.
Lit Lit
During PT-9500PC standby
No tape cassette
Install the tape cassette and close the
tape compartment cover.
During PT-9500PC standby
Tape compartment cover is
open.
Close the cover.
Lit Flashing
During printing
No tape cassette
Incorrect tape cassette
Install the correct tape cassette and close
the tape compartment cover.
During printing
Tape compartment cover is
open.
Close the cover.
Empty tape cassette
Install a tape cassette containing tape
and close the tape compartment cover.
Transmission error
The PT-9500PC will return to standby
after 5 seconds.
Lit Flashing fast
Cutter error Confirm that the tape is not jammed in
the PT-9500PC. If necessary, turn the
PT-9500PC off and on.
If the ERROR lamp continues to flash,
contact the retail outlet where the
PT-9500PC was purchased or your local
authorized service center.
Roller holder error
Lit
Flashing very
fast
EEPROM error
Circuit board error
Turn the PT-9500PC off and on.
If the ERROR lamp continues to flash,
contact the retail outlet where the
PT-9500PC was purchased or your local
authorized service center.