Label Printer Quick Reference
Table Of Contents
- PT9500PC_Ca-E_Ca-Fr.pdf
- English
- Introduction
- Table of Contents
- 1 Before use
- 2 Installing the software
- 3 Creating labels: Windows version
- 4 Creating labels: Macintosh version
- 5 Appendix
- French
- Introduction
- Table des matières
- 1 Avant l'utilisation de l'imprimante
- 2 Installation du logiciel
- Types de logiciels utilisés
- Sous Windows
- Précautions relatives à l'installation
- Installation de base
- Installation du logiciel P-touch Editor uniquement
- Installation du logiciel P-touch Quick Editor uniquement
- Installation du pilote d'imprimante uniquement
- Réglage de la vitesse de transmission du PC et de la PT-9500PC
- Désinstallation du logiciel
- L'imprimante n'est plus utilisée
- Sous Mac OS 8.6-9.x
- Sous Mac OS X 10.1 ou version ultérieure
- 3 Création d'étiquettes : version Windows
- 4 Création d'étiquettes : version Macintosh
- 5 Annexes
- English
104
■
Cleaning tape
Use the TZ-CL6 cleaning tape with a tape
width of 11/2” (36 mm) (sold separately) to
clean the PT-9500PC easily.
1
Press the cover release button and open
the tape compartment cover.
2
Remove the tape cassette and install the
cleaning tape.
3
Close the tape compartment cover.
4
Press the feed/cut button.
→
Cleaning will start.
5
Press the cover release button and open
the tape compartment cover.
When the rollers stop, press the cover
release button.
6
Remove the cleaning tape, reinstall the
tape cassette, and then close the tape
compartment cover.
Cleaning the cutter
If the printed labels are not ejected from the
PT-9500PC correctly, clean the cutter for
cutting the labels.
1
Turn off the PT-9500PC.
2
Press the cover release button and open
the tape compartment cover.
3
Remove the tape cassette.
4
Use a cotton swab to clean the cutter.
Note
●
For further details on using the cleaning
tape, refer to the instruction manual
included with the cleaning tape.
Cutter blade
Cotton swab
Metal section