Quick Start Manual
Table Of Contents
- Contents
- Before Using
- Getting Started
- Introduction
- About this Chapter
- Using the Auto Punch Function
- Using Design Center
- Using Layout & Editing
- Step 1 Starting Layout & Editing
- Step 2 Importing Embroidery Patterns from Design Center
- Step 3 Zooming In and Out
- Step 4 Moving the Embroidery Pattern
- Step 5 Adding an Oval
- Step 6 Adjusting the Size and Location of the Oval
- Step 7 Adding Text
- Step 8 Fitting the Text around the Oval
- Step 9 Moving the Oval and Text
- Step 10 Adding a Circle for Drawing the Sun
- Step 11 Selecting a Programmable Fill Stitch
- Step 12 Adding Broken Lines for Drawing the Sun Rays
- Step 13 Changing the Sewing Order of Sun and Rays
- Step 14 Adjusting the Rays
- Step 15 Setting Hole Sewing
- Step 16 Previewing the Sewing Image
- Step 17 Transferring the Data to a Card
- Step 18 Saving the File
- Using Programmable Stitch Creator
- Creating data for the multi-position frame
- Design Center
- The Screen
- Using the Stage 2 Tool Box
- Using the Stage 3 Tool Box
- Using the Stage 4 Tool Box
- Using the Sewing Attributes Bar
- Using the Menu Bar and the Toolbar
- Layout & Editing
- The Screen
- Using the Tool Box
- Using the Sewing Attributes Bar
- Using the Menu Bar and the Toolbar
- File Menu
- Edit Menu
- Image Menu
- Input – from File
- Input – from TWAIN device
- Input – from Portrait
- Input – from Clipboard
- Output – to File
- Output – to Clipboard
- Select TWAIN device
- Modify
- Image to Stitch Wizard
- If Auto Punch is selected:
- If Photo Stitch 1 (Color) is selected:
- [Manual Color Selection]
- If Photo Stitch 1 (Mono) is selected:
- If Photo Stitch 2 (Color) is selected:
- If Photo Stitch 2 (Mono) is selected:
- If Cross Stitch is selected:
- Display Image – On/Faded/Off
- Text Menu
- Sew Menu
- Display Menu
- Option Menu
- Help Menu
- Programmable Stitch Creator
- Quick Reference
- Alphabetic Index
26
Contents Before Using Getting Started Design Center Layout & Editing
Programmable
Stitch Creator
Quick Reference Alphabetic Index
For the leaves:
Click the Region color button on the Sewing Attributes bar to display the Region Thread Color
dialog, then select the LEAF GREEN color.
The Region color button shows the selected color.
Click the Region sew type selector on the Sewing Attributes bar, then click Fill Stitch.
To set the characteristics of the fill stitch, click Sew on the menu bar, then click Sewing Attribute on
the submenu. You can also click the button of the Toolbar shown below.
The
Sewing Attribute Setting
dialog appears. The dialog displays the default settings for the region stitch.
◆ Set the direction of the fill stitch as explained in the “NOTE” below.
◆ Click on the regions of the leaves to which you want to apply a setting.
◆ Repeat the same operation for each stitch direction.
NOTE:
Using different directions for different regions can add contrast and improve the appearance of the
embroidery.
NOTE:
To be able to apply the sewing settings to a region, the region has to be closed. If you cannot apply
any setting to a given region, go back to the Figure Handle stage and make sure that region is closed.
Edit any faulty line with the Point Edit tool. For details on how to edit the figure handle image, see
“Point Edit Mode” on page 68.
Set the direction to 45˚ and click.
Set the direction to 90˚ and click. Set the direction to 135˚ and click.