Quick Start Manual

20
Contents Before Using Getting Started Design Center Layout & Editing
Programmable
Stitch Creator
Quick Reference Alphabetic Index
Step 4 Editing Lines
At this step, you might normally need to correct a few lines. You should especially make sure that the lines
around regions are completely closed or intersect to form a region. You may also wish to edit a line image and
either add or remove some details or your image. You can do this at this stage using the pens and erasers of
the Tool Box.
In this example, you are going practice how to use an eraser to remove some of the outline.
1 To make your editing job easier, enlarge the image using the zoom function.
Click on the Tool Box. The shape of the cursor changes to when you move
it over the work area.
2 Drag the cursor over the pattern and click. The area is enlarged as soon as you
release the mouse. You can repeat this step several times. To zoom in on a specific
area, position the cursor to a point just next to the area, then click the left mouse but-
ton and hold it down as you move the cursor diagonally. A dotted box appears as you
drag and the selected area will be magnified when you let go of the mouse button.
For a more complete description of the zoom features, see “Zoom-in Mode”, “Zoom-
out Mode” and “Fit Design Page to Window” on page 64.
3 Click on the Tool Box. The shape of the cursor changes to when you move
it over the work area.
4 Position the cursor over the first line you want to erase. Click and hold the right button
of the mouse. The shape of the cursor changes to .
5 Carefully erase the line, then move the cursor to the next line to erase and scroll the
image as needed. Repeat this procedure to delete a few petals and leaves.
NOTE:
If you deleted parts of the outline by mistake, you may need to redraw some of lines.
To do this, simply hold down the left mouse button and start drawing the line.
If you are not satisfied with your editions, you can go back to Stage 1, convert your
pattern and start editing again.