Quick Start Manual
Table Of Contents
- Contents
- Before Using
- Getting Started
- Introduction
- About this Chapter
- Using the Auto Punch Function
- Using Design Center
- Using Layout & Editing
- Step 1 Starting Layout & Editing
- Step 2 Importing Embroidery Patterns from Design Center
- Step 3 Zooming In and Out
- Step 4 Moving the Embroidery Pattern
- Step 5 Adding an Oval
- Step 6 Adjusting the Size and Location of the Oval
- Step 7 Adding Text
- Step 8 Fitting the Text around the Oval
- Step 9 Moving the Oval and Text
- Step 10 Adding a Circle for Drawing the Sun
- Step 11 Selecting a Programmable Fill Stitch
- Step 12 Adding Broken Lines for Drawing the Sun Rays
- Step 13 Changing the Sewing Order of Sun and Rays
- Step 14 Adjusting the Rays
- Step 15 Setting Hole Sewing
- Step 16 Previewing the Sewing Image
- Step 17 Transferring the Data to a Card
- Step 18 Saving the File
- Using Programmable Stitch Creator
- Creating data for the multi-position frame
- Design Center
- The Screen
- Using the Stage 2 Tool Box
- Using the Stage 3 Tool Box
- Using the Stage 4 Tool Box
- Using the Sewing Attributes Bar
- Using the Menu Bar and the Toolbar
- Layout & Editing
- The Screen
- Using the Tool Box
- Using the Sewing Attributes Bar
- Using the Menu Bar and the Toolbar
- File Menu
- Edit Menu
- Image Menu
- Input – from File
- Input – from TWAIN device
- Input – from Portrait
- Input – from Clipboard
- Output – to File
- Output – to Clipboard
- Select TWAIN device
- Modify
- Image to Stitch Wizard
- If Auto Punch is selected:
- If Photo Stitch 1 (Color) is selected:
- [Manual Color Selection]
- If Photo Stitch 1 (Mono) is selected:
- If Photo Stitch 2 (Color) is selected:
- If Photo Stitch 2 (Mono) is selected:
- If Cross Stitch is selected:
- Display Image – On/Faded/Off
- Text Menu
- Sew Menu
- Display Menu
- Option Menu
- Help Menu
- Programmable Stitch Creator
- Quick Reference
- Alphabetic Index
177
Contents Before Using Getting Started Design Center Layout & Editing
Programmable
Stitch Creator
Quick Reference Alphabetic Index
Operation:
1 Check that the scanner or other device is correctly connected.
2 Click Image, then Input, then from TWAIN device.
The driver interface set in the
Select TWAIN device dialog is displayed.
Operate that interface, make the settings for importing an image, and import the image.
NOTE:
For information on using the interface, see the help manual for that interface, or contact the manu-
facturers of the interface.
3 When the image transfer between the scanner (or other device) and the driver is complete, the
imported image will be pasted in Design Page.
If the current image is not saved, you will be asked whether you want to save it.
NOTE:
TWAIN is an application interface (API) standardization for software controlling scanners, etc.
Also, the software itself is called TWAIN.
This software supports TWAIN standardized devices, so you can control the scanner and import
the image directly.
Before using this function, you must go to the
Select TWAIN device dialog to select a TWAIN device.
■ Input – from Portrait
Purpose: Combine images of facial features that are built in to the program to create an
original portrait.
Shortcut key: No shortcut key for this function
Toolbar: No button for this function
Operation:
1 Click Image, then Input, then from Portrait.
A dialog similar to the one shown below appears.
◆ Click
OK to save the image.
◆ Click Cancel to finish without saving the image.