Quick Start Manual

93
Contents Before Using Getting Started Design Center Layout & Editing
Programmable
Stitch Creator
Quick Reference Alphabetic Index
Operation:
1 Select one or more outline data (Stage 3 only).
2 Click Edit, then Delete.
The selected outline data are removed from the screen. Since they are not saved in the clipboard,
the only way to make them reappear is to use
Edit – Undo.
See also: “Undo” and “Cut” on page 91
■ Mirror – Horizontal
Purpose: Flips the selected data up/down.
Shortcut key: +
Toolbar:
Operation:
1 Select one or more outline data (Stage 3 only).
2 Click Edit, then Mirror, then Horizontal.
A horizontal mirror image (top and bottom inverted) of the outline data appears on the screen.
Two successive executions of this command restores the original image.
See also: “Flipping a pattern horizontally or vertically” on page 67 and “Mirror – Vertical”
below
■ Mirror – Vertical
Purpose: Flips the selected data left/right.
Shortcut key: +
Toolbar:
Operation:
1 Select one or more outline data (Stage 3 only).
2 Click Edit, then Mirror, then Vertical.
A vertical mirror image (left and right inverted) of the outline data appears on the screen.
Two successive executions of this command restores the original image.
See also: “Flipping a pattern horizontally or vertically” on page 67 and “Mirror – Horizontal”
above
Ctrl H
Ctrl J