ESC/ P Command Reference

42
B or b: Beginning of bar code data
? (generate check digit)
Generates a check digit when “?” is in the bar code data
The position of “?” is irrelevant as long as it is within the bar code data.
E or e (deleting brackets on GS1-128)
e0: ON (deleted)
e1: OFF (not deleted)
Backslash: End of bar code data
Both 00H through 09H and 30H through 39H are recognized as the parameter numbers 0
through 9.
If there is no type command or if the type command is invalid, Code 39 is used.
The number of characters that can be entered for each type is as follows:
MW-120 and MW-140BT TypeE:
t0: 2 to 20 characters
t1: 3 to 22 characters
t5: 7 characters (for EAN-8)
12 characters (for EAN-13)
11 characters (for UPC-A)
t6: 6 characters
t9: 4 to 22 characters
*MW-120 TypeF, MW-140BT TypeF, MW-145BT and MW-260:
t0: 2 to 50 characters
t1: 3 to 64 characters
t5: 7 characters (for EAN-8)
12 characters (for EAN-13)
11 characters (for UPC-A)
t6: 6 characters
t9: 4 to 64 characters
ta: 1 to 64 characters
tb: 1 to 64 characters
[Description]
・ Specifies a bar code image.
*The following 2D codes are available for MW-120 TypeF, MW-140BT TypeF, MW-145BT and MW-260.