ESC/ P Command Reference
Table Of Contents
- Chapter 1. General Information
- Chapter 2. Command information
- 2-1) Character/style selection commands
- 2-2) Text printing commands
- ESC 4 Apply italic style
- ESC 5 Cancel italic style
- ESC E Apply bold style
- ESC F Cancel bold style
- ESC G Specify double printing
- ESC H Cancel double printing
- ESC P Specify pica pitch
- ESC M Specify elite pitch
- ESC g Specify micron pitch
- ESC p Specify proportional characters
- ESC W Specify double-width characters
- SO Specify auto-cancelling enlarged characters
- ESC SO Specify auto-cancelling enlarged characters
- SI Specify half-width characters
- ESC SI Specify half-width characters
- DC2 Cancel half-width characters
- DC4 Cancel auto-cancelling double-width characters
- ESC - Apply/cancel underlining
- ESC ! Global formatting
- ESC SP Select character spacing for ANK characters
- ESC X Select alphanumeric/kana character size
- 2-3) Line feed amount commands
- 2-4) Horizontal movement commands
- 2-5) Vertical movement commands
- 2-6) Paper formatting
- 2-7) Printer control commands
- 2-8) Graphics commands
- 2-9) Advanced commands
- Chapter 3. Appendix
3
Notes for using Bluetooth
When you are connecting the machine via Bluetooth, the printer may not start to receive the data immediately
after the port is opened. We advise to wait for an interval of 500 msec before sending the print data to the
machine.
If you normally close and re-open the Bluetooth port between prints, we would again advise to leave 500 msec
between the port being closed and re-opened.
Also, once you have sent the print data, and the printing process has begun, do not close the port. Please
ensure 32 bytes of data has been received by the printer, and then close the port.