ESC/ P Command Reference
Table Of Contents
- Chapter 1. General Information
- Chapter 2. Command information
- 2-1) Character/style selection commands
- 2-2) Text printing commands
- ESC 4 Apply italic style
- ESC 5 Cancel italic style
- ESC E Apply bold style
- ESC F Cancel bold style
- ESC G Specify double printing
- ESC H Cancel double printing
- ESC P Specify pica pitch
- ESC M Specify elite pitch
- ESC g Specify micron pitch
- ESC p Specify proportional characters
- ESC W Specify double-width characters
- SO Specify auto-cancelling enlarged characters
- ESC SO Specify auto-cancelling enlarged characters
- SI Specify half-width characters
- ESC SI Specify half-width characters
- DC2 Cancel half-width characters
- DC4 Cancel auto-cancelling double-width characters
- ESC - Apply/cancel underlining
- ESC ! Global formatting
- ESC SP Select character spacing for ANK characters
- ESC X Select alphanumeric/kana character size
- 2-3) Line feed amount commands
- 2-4) Horizontal movement commands
- 2-5) Vertical movement commands
- 2-6) Paper formatting
- 2-7) Printer control commands
- 2-8) Graphics commands
- 2-9) Advanced commands
- Chapter 3. Appendix
25
・ This mode is cancelled using CR, ESC $, ESC \, ESC ( V, ESC ( v.
ESC SO Specify auto-cancelling enlarged characters
[ASCII] ESC SO
[Decimal] 27 14
[Hexadecimal] 1B 0E
[Parameters] None
[Description]
・ Same as SO
SI Specify half-width characters
[ASCII] SI
[Decimal] 15
[Hexadecimal] 0F
[Parameters] None
[Description]
・ Prints the following data in half-width characters.
ESC SI Specify half-width characters
[ASCII] ESC SI
[Decimal] 27 15
[Hexadecimal] 1B 0F
[Parameters] None
[Description]
・ Same as SI
DC2 Cancel half-width characters
[ASCII] DC2
[Decimal] 18
[Hexadecimal] 12
[Parameters] None
[Description]
・ Cancels the half-width characters specified using SI.