Multi-Protocol Print Server Network User's Guide

CONFIGURING INTERNET PRINTING FOR WINDOWS
®
5 - 6
Brother Internet Print: Using TELNET to Configure
the Print Server
1 When you get the Local> prompt after connecting to the
console, enter the command:
SET POP3 ADDRESS address
where ipaddress is the address of your POP3 server (consult
with your network administrator if you do not know this address).
2 Enter the command:
SET POP3 NAME mailboxname
SET POP3 PASSWORD emailpassword
where mailboxname is the name of the remote print server
mailbox and emailpassword is the password associated with
this mailbox. Usually the mailbox name is the same as the first
part of the E-mail address that you defined previously (for
example, usually if the E-mail address is [e-mail],
then the mailbox name is emailprinter).
3 The print server is set by default to poll the POP3 server every 30
seconds. If you wish to change this value, enter the command:
SET POP3 POLLING rate
where rate is the polling rate in seconds.
Type EXIT to exit the console and save the changes. You have
now completed configuring the print server.
Skip this section if you used BRAdmin or a Web Browser to
configure the remote print server.
As an alternative to BRAdmin, you can use the print server
remote console to configure the print server. The console can
be accessed via TELNET. When you access the print server
using these utilities, you will be asked for a password. The
default password is access.