Server User Manual
Table Of Contents
- Network User’s Guide
- Applicable models
- Definitions of notes
- IMPORTANT NOTE
- Table of Contents
- Section I: Network Operation
- 1 Introduction
- 2 Changing your machine’s network settings
- 3 Configuring your machine for a wireless network (For HL-5470DW(T) and HL-6180DW(T))
- Overview
- Confirm your network environment
- Wireless configuration temporarily using a USB cable (Recommended for Windows®)
- Configuration using the machine’s control panel Setup Wizard
- One push configuration using WPS (Wi-Fi Protected Setup) or AOSS™
- Configuration using the PIN Method of WPS (Wi-Fi Protected Setup)
- Configuration in Ad-hoc mode (For IEEE 802.11b)
- 4 Control panel setup
- Overview
- Network menu (For HL-5470DW(T) and HL-6180DW(T))
- Reset the network settings to the factory default
- Printing the Printer Settings Page (For HL-5450DN(T))
- Printing the Network Configuration Report (For HL-5470DW(T) and HL-6180DW(T))
- Printing the WLAN report (For HL-5470DW(T) and HL-6180DW(T))
- Function table and default factory settings
- 5 Web Based Management
- 6 Security features
- Overview
- Managing your network machine securely using SSL/TLS
- Secure Management using BRAdmin Professional 3 (Windows®)
- Printing documents securely using SSL/TLS
- Sending an E-mail securely
- Using IEEE 802.1x authentication
- Using Certificates for device security
- Managing multiple certificates
- 7 Troubleshooting
- Section II: Network Glossary
- 8 Types of network connections and protocols
- 9 Configuring your machine for a network
- 10 Wireless network terms and concepts (For HL-5470DW(T) and HL-6180DW(T))
- 11 Additional network settings from Windows®
- Types of additional network settings
- Installing drivers used for printing via Web Services (Windows Vista® and Windows® 7)
- Uninstalling drivers used for printing via Web Services (Windows Vista® and Windows® 7)
- Network printing installation for Infrastructure mode when using Vertical Pairing (Windows® 7)
- 12 Security terms and concepts
- Section III: Appendixes
- Index
58
Security features
6
Managing your network machine securely using SSL/TLS 6
To manage your network machine securely, you need to use the management utilities with security protocols.
Secure Management using Web Based Management (web browser) 6
We recommend to use HTTPS and SNMPv3 protocol for secure management. To use these protocols, the
following machine settings are required.
Note
The HTTPS protocol is enabled by default.
You can change the HTTPS protocol settings on the Web Based Management screen, by clicking
Network, Protocol and then HTTP Server Settings.
a Start your web browser.
b Type “https://Common Name/” into your browser. (Where “Common Name” is the Common Name that
you assigned for the certificate, such as an IP address, node name or domain name. For how to assign
a Common Name for the certificate, see Using Certificates for device security uu page 66.)
For example:
https://192.168.1.2/ (if the Common Name is the machine’s IP address)
c No password is required by default. Enter a password if you have set one and press .
d You can now access the machine using HTTPS.
If you use the SNMPv3 protocol, follow the steps below.
Note
You can also change the SNMP settings by using BRAdmin Professional 3.
e Click Network.
f Click Protocol.