Laser Multifunction Printer Owner's Manual

CHAPTER EIGHT

ERROR MESSAGE CAUSE ACTION

COVER OPEN The front cover was not completely closed. Open, then close the front cover.

DOCUMENT JAM Documents were not inserted or fed Do not pull paper out until you see

properly or document was too long. “Document Jams and Paper Jams” in

this chapter.

MACHINE ERROR XX

MFC has a mechanical problem Cut the power off. Then contact your

Brother dealer for service.

MEMORY FULL You can’t store data in the memory. See “If You Get a Memory Full

Message” in chap. 3.

PLS CLEAN DRUM The primary corona wire of drum unit is Clean the primary corona wire of drum

dirty. unit.

PLS OPEN COVER A page, piece of paper or paper clip, etc. Open the front cover. If you see any

may be jammed inside the machine. jammed paper or other item, gently pull

it out, then close the front cover. If the

error message remains, open and close

the front cover again. If the machine

cannot reset itself and return to the

ready prompt, it will display

MACHINE ERROR XX. Please call

your Brother dealer for service.

PRINTER JAM The recording paper is jammed in the MFC. See Printer Jam in this chapter.

TONER EMPTY Toner cartridge is not installed. Toner is Reinstall the toner cartridge. Replace

used up and printing is not possible. the toner cartridge with a new one. (See

“Replacing the Toner Cartridge” in this

chapter).

CHANGE TONER If the display shows CHANGE TONER Order a new toner cartridge now.

and at the same time the Toner Empty LED

on the control panel flashes on and off, you

can still print. But the toner is depleted and

the machine is telling you that the toner will

soon run out.