User Manual

Chapter 7
50
j Change any additional settings from the
options shown on the LCD.
k Press OK to confirm to use watermark.
l If you do not want to change additional
settings, press Black Start or
Color Start.
IMPORTANT
DO NOT take out the memory card or
USB Flash memory drive while
PHOTO CAPTURE is blinking to avoid
damaging the card, USB Flash memory
drive, or the data stored on them.
Using a scanned paper document as
your watermark
7
a Press (COPY).
b Enter the number of copies you want.
c Press d or c to display
Advanced Settings.
d Press Advanced Settings.
e Press Watermark Copy.
f Press Use Image.
g Press Scan. Place the page that you
want to use as a watermark on the
scanner glass.
h Press Black Start or Color Start.
i Take out the watermark document you
scanned and load the document you
want to copy.
j Press Transparency, and then press
d or c to change the Transparency of
the watermark.
Press OK.
k Press OK.
l Press OK to confirm to use watermark.
m If you do not want to change any
additional settings, press Black Start or
Color Start.
Note
You cannot enlarge or reduce the
scanned watermark.
Duplex (2-sided) copying 7
You can reduce the amount of paper used for
copies by copying on both sides of the paper.
We recommend you load your document in
the ADF for duplex copying.
Note
• You can copy 2-sided documents up to
Legal size using the ADF.
• You can only use plain paper sizes Letter,
Legal, Ledger, A4, A5, A3 or Executive
a Press Duplex on the machine’s panel.
b Load your document.
If you want to copy a 2-sided document,
load your document in the ADF.
c Press Copy.
d Do one of the following:
 If you are copying Ledger or A3 size
document, go to step e.
 If you are copying Letter, Legal, A4,
A5 or Executive size document, go to
step h.
e Press More.
f Press
A3/LGR Duplex Copy Setting.
Note
N in 1 copy is not available with
A3/LGR Duplex Copy Setting.