User Manual

68
11
Scanning a document 11
There are several ways to scan documents.
You can use the SCAN key on the machine or
the scanner drivers on your computer.
a To use the machine as a scanner, install
a scanner driver. If the machine is on a
Network, configure it with a TCP/IP
address.
 Install the scanner drivers on the
Installation CD-ROM. (See the Quick
Setup Guide and Scanning in the
Software User’s Guide.)
 Configure the machine with a TCP/IP
address if network scanning does not
work. (See Configuring Network
Scanning in the Software User’s
Guide.)
b Load your document. (See How to load
documents on page 28.)
 Use the ADF to scan multiple pages
of documents or 2-sided documents.
It feeds each sheet automatically.
 Use the scanner glass to scan a
page of a book or one sheet at a
time.
c Do one of the following:
 To scan using the SCAN key, go to
Scanning using the scan key.
 To scan using a scanner driver at
your computer, go to Scanning using
a scanner driver.
Scanning using the
scan key
11
For more information, see Using the Scan
key in the Software User’s Guide.
a Press (SCAN).
b Choose the scan mode you want.
 to File
 to Media
 to Network
 to FTP
 to Email
 to OCR
1
 to Image
1
(Macintosh users)
Presto! PageManager must be downloaded
and installed before use. See Accessing
Brother Support (Macintosh) on page 3 for
further instructions.
c (For network users)
Choose the computer you want to send
the data to.
d Press Start to begin scanning.
How to scan to a computer 11