User Manual
Table Of Contents
- Product Safety Guide
- Symbols and Conventions Used in the Documentation
- Compilation and Publication Notice
- Choose a Safe Location for Your Product
- Connect the Product Safely
- Use the Product Safely
- Product Warranty & Liability
- Approval Information (MFC Models Only)
- Wiring Information (U.K. Only)
- Declaration of Conformity (Europe Only)
- Declaration of Conformity for RE Directive 2014/53/EU (Europe Only) (Applicable to Models with Radio Interfaces)
- Wireless LAN (Models with Wireless LAN Function Only)
- NFC (Models with NFC Function Only)
- LAN Connection (Models with Wired LAN Function Only)
- Recycling Information in Accordance with the WEEE and Battery Directives
- Imaging Equipment Voluntary Agreement
- Chemical Substances (EU REACH)
- Trademarks
- Open Source Licensing Remarks
- Copyright and License
- Brother Customer Service
- Unlawful Use of Copying or Scanning Equipment (Products with scanning function only)
WARNING
DO NOT use this product near water, for example, near a bath tub, wash bowl, kitchen sink or
washing machine, in a wet basement or near a swimming pool.
Avoid using this product during a thunderstorm. There may be a remote risk of electrical
shock from lightning.
DO NOT use this product to report a gas leak in the vicinity of the leak.
Only use the power cord supplied with this product (if included in the box).
Disconnect device
This product must be installed near an electrical socket that is easily accessible. In case of an
emergency, you must unplug the power cord from the electrical socket to shut off the power
completely.
Approval Information (MFC Models Only)
THIS EQUIPMENT IS DESIGNED TO WORK WITH A TWO WIRE ANALOGUE PSTN LINE
FITTED WITH THE APPROPRIATE CONNECTOR.
Brother advises that this product may not function correctly in a country other than where it was
originally purchased, and does not offer any warranty in the event that this product is used on
public telecommunication lines in another country.
Wiring Information (U.K. Only)
If you need to replace the fuse in the plug, fit a fuse that is approved by ASTA to BS1362 with
the same rating as the original fuse. Always replace the fuse cover. Never use a plug that does
not have a cover. If in any doubt, call a qualified electrician.
Warning - This product must be earthed.
The wires in the mains lead are coloured in line with the following code:
16