Owner`s manual

150 Chapter 19
15 Unplug this product from the mains power and telephone line sockets, and refer servicing to
qualified service personnel under the following conditions:
◆ When the power cord is damaged or frayed.
◆ If liquid has been spilled into the product.
◆ If the product has been exposed to rain or water.
◆ If the product does not operate normally when the operating instructions are followed.
Adjust only those controls that are covered by the operating instructions. Improper
adjustment of other controls may result in damage and will often require extensive work by
a qualified technician to restore the product to normal operation.
◆ If the product has been dropped or the cabinet has been damaged.
◆ If the product exhibits a distinct change in performance, indicating a need for service.
16 We do not advise the use of an extension lead.
Important Information for New Zealand
Important Safety Instructions
1 Read all of these instructions.
2 Save them for later reference.
3 Follow all warnings and instructions marked on the product.
4 Unplug this product from the telephone and AC sockets (in this order) before cleaning. Do not
use liquid or aerosol cleaners. Use a damp cloth for cleaning.
5 Do not use this product near water.
6 The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It
indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.
Above all, it provides no assurance that any item will work correctly in all respects with another
item of Telepermitted equipment of a different make or model, nor does it imply that any
product is compatible with all of Telecom’s network services.
7 This equipment does not fully meet Telecom’s impedance requirements. Performance
limitations may occur when used in conjunction with some parts of the network. Telecom will
accept no responsibility should difficulties arise in such circumstances.
8 If a charge for local calls is unacceptable, the “Dial Button” should not be used for local calls.
Only the 7-digits of the local number should be dialled from your telephone. Do not dial the area
code digit or the “0” prefix.
9 This equipment shall not be set to make automatic calls to the Telecom ‘111’ Emergency Service.
10 IMPORTANT NOTICE
Under power failure conditions, this telephone may not operate. Please ensure that a separate
telephone, not dependent on local power, is available for emergency use in emergencies.
11 Some parameters required for compliance with Telecom’s Telepermit requirements are
dependent on the equipment (PC) associated with this device. In order to operate within the
limits for compliance with Telecom’s Specifications, the associated equipment shall be set to
ensure that calls are answered between 3 and 30 seconds of receipt of ringing.