User Manual

126
B
Memory board B
This machine has 64 MB of standard memory
and one slot for optional memory expansion.
You can increase the memory up to a
maximum of 576 MB by installing one SO-
DIMM (Small Outline Dual In-line Memory
Module). When you add the optional memory,
it increases the performance for both copier
and printer operations.
In general, the machine uses
industry-standard SO-DIMM with the
following specifications:
Type: 144 pin and 64 bit output
CAS latency: 2
Clock frequency: 100 MHz or more
Capacity: 64, 128, 256 or 512 MB
Height: 31.75 mm
Dram Type: SDRAM 2 Bank
Note
• There might be some SO-DIMMs that will
not work with the machine.
• For more information, contact your
Brother dealer.
Installing extra memory B
a Turn off the machine’s power switch.
Unplug the telephone line cord.
b Disconnect the interface cable from the
machine, and then unplug the power
cord from the electrical socket.
Note
Be sure to turn off the machine’s power
switch before you install or remove the
SO-DIMM.
c Remove the plastic (1) and then
metal (2) SO-DIMM covers.
d Unpack the SO-DIMM and hold it by its
edges.
IMPORTANT
To prevent damage to the machine from
static electricity, DO NOT touch the
memory chips or the board surface.
Options B
1
2