User Manual
Table Of Contents
- Quick Setup Guide MFC-9325CW
- Start Here
- 1 Unpack the machine and check the components
- 2 Remove the packing material from the machine
- 3 Install the drum unit and toner cartridge assemblies
- 4 Load paper in the paper tray
- 5 Connect the power cord and telephone line
- 6 Set your country (for Australia/New Zealand customer only)
- 7 Choose a Receive Mode
- 8 Set the LCD contrast (if needed)
- 9 Set the date and time
- 10 Enter personal information (station ID)
- 11 Fax Transmission Report
- 12 Set tone or pulse dialling mode (not available for New Zealand)
- 13 Dial Prefix
- 14 Automatic Daylight Savings Time
- 15 Choose your connection type
- For USB Interface Users (Windows® XP/XP Professional x64 Edition/Windows Vista®/ Windows® 7)
- For USB Interface Users(Mac OS X 10.4.11 - 10.6.x)
- For Wired Network Interface Users(Windows® XP/XP Professional x64 Edition/Windows Vista®/Windows® 7)
- For Wired Network Interface Users(Mac OS X 10.4.11 - 10.6.x)
- For Wireless Network Interface Users
- 16 Before you begin
- 17 Choose your wireless install method
- Configuration using the Installation CD-ROM and temporarily using a USB cable (For Windows® Users)
- Configuration using the Installation CD-ROM and temporarily using a USB cable (For Macintosh Users)
- Manual configuration from the control panel
- One push configuration using Wi-Fi Protected Setup or AOSS™
- Install the Drivers & Software (Windows® XP/XP Professional x64 Edition/Windows Vista®/ Windows® 7)
- Install the Drivers & Software (Mac OS X 10.4.11 - 10.6.x)
- For Network Users
- Options and Consumables
- Start Here
33
Windows
®
Wireless Network
Wireless Network
Windows
®
Macintosh
m Enter the Network Key you wrote down in
step 17-a on page 28 and then enter the key
again in Confirm Network Key, then click
Next.
n Click Next. The settings will be sent to your
machine.
o Disconnect the USB cable between the
computer and the machine.
p Click Next to continue to install MFL-Pro Suite.
To install MFL-Pro Suite, continue to
step 20-f on page 41.
Now go to
page 41
Note
• The settings will remain unchanged if you click
Cancel.
• If you want to manually enter the IP address
settings of your machine, click Change IP
Address and enter the necessary IP address
settings for your network.
• If the wireless setup failure screen appears,
click Retry.
Wireless setup is now complete. A four
level indicator at the right of your
machine's LCD will show the wireless
signal strength of your access
point/router.