User Manual

SETUP SEND 6 - 10
Dual Access
You can dial a number, and begin scanning the fax into memory—
even when the MFC is receiving, sending or printing a fax from
memory. The LCD shows the new job number.
1
If it is not illuminated in green, press (
Fax
). Place the
document face up in the ADF, or face down on the scanner
glass.
2
Enter the fax number.
3
Press
Start
to send the fax.
The MFC starts scanning the first page and the LCD shows the
job number (#XXX) of the fax. You can repeat Steps 1 to 3 for
the next fax.
—OR—
If you are using the scanner glass, go to Step 4.
4
To send a single page,
press
2
(or press
Start
again).
The MFC starts sending the
document.
—OR—
To send more than one page,
press
1
and go to Step 5.
5
Place the next page on the
scanner glass.Press
Set
.
The MFC starts scanning, and
then returns to Step 4. (Repeat
Steps 4 and 5 for each additional
page). To send the next fax, go to Step 1.
If you get a
Out of Memory
message while scanning the first
page of a fax, press
Stop/Exit
to cancel scanning. If you get a
Out of Memory
message while scanning a subsequent page,
you can press
Start
to send the pages scanned so far, or press
Stop/Exit
to cancel the operation.
Flatbed Fax:
Next Page?
▲
1.Yes
▼
2.No(Send)
Select
▲▼
& Set
Flatbed Fax:
Set Next Page
Then Press Set