User Guide

Chapter 12
92
Tray selection 12
You can change the Tray Use only for the
next copy.
a Make sure you are in Copy mode .
b Load your document.
c Use the dial pad to enter the number of
copies (up to 99).
d Press Tray Select.
e Press d or c to choose the MP>T1,
T1>MP, #1(XXX)
1
or MP(XXX)
1
.
Press OK.
f Press Start.
1
XXX is the paper size you set in Menu, 1, 2, 2.
Note
• T2 or #2 appears only if the optional paper
tray is installed.
• To change the default setting for Tray
Select, see Tray Use in copy mode
on page 23.
Out of memory
message 12
If the memory becomes full while you are
making copies, the LCD message will guide
you through the next step.
If you get an Out of Memory message
while scanning a subsequent page, you will
have the option to press Start to copy the
pages scanned so far, or to press Stop/Exit
to cancel the operation.
To gain extra memory, you can do the
following:
 Print the faxes that are in the memory.
(See Printing a fax from the memory
on page 53.)
 You can turn off Fax Storage. (See
Turning off Remote Fax Options
on page 74.)
Note
When you get an Out of Memory
message, you may be able to make
copies if you first print incoming faxes in
the memory to restore the memory to
100%.
Press MP>T1 or M>T1>T2
T1>MP or T1>T2>M
#1(XXX)
1
#2(XXX)
1
MP(XXX)
1