User Manual
Table Of Contents
- Quick Setup Guide MFC-7420/MFC-7820N
- Getting Started
- Table of Contents
- Step1 Setting Up the Machine
- Step2 Installing the Drivers & Software
- Supplied CD-ROM “MFL-Pro Suite”
- For USB Interface Cable Users (For Windows® 98/98SE/Me/2000 Professional/XP)
- For Parallel Interface Cable Users (For Windows® 98/98SE/Me/2000 Professional/XP)
- For Windows NT® Workstation Version 4.0 Users
- For Network Interface Cable Users (MFC-7820N and Optional NC-2200w only) (For Windows® 98/98SE/Me/NT/2000 Professional/XP)
- For USB Interface Cable Users
- For Network Interface Cable Users (MFC-7820N only)
- For Network Users
- Options and Consumables
- brother ARL/ASA/NZ
5
Setting Up
the Machine
Windows
®
USB
Windows
®
Parallel
Windows
NT
®
4.0
Parallel
Macintosh
®
USB
Macintosh
®
Network
Windows
®
Network
For
Network Users
1
Pull the paper tray completely out of the
machine.
2
While pressing the paper guide release
lever, slide the adjusters to fit the paper
size. Check that the guides are firmly in the
slots.
3
Fan the stack of paper well to avoid paper
jams and misfeeds.
4
Put paper in the paper tray.
Check that the paper is flat in the tray and
below the maximum paper mark.
5
Put the paper tray firmly back in to the
machine and unfold the output tray support
flap before you use the machine.
2
Load Paper in the Paper
Tray
For Legal size paper, press in the inside
latches and pull out the back of the paper
tray.
For details on supported paper
specifications, see “About paper” in Chapter
1 of the User’s Guide.
Maximum
paper mark