Quick Setup Guide

IEC 60825-1 Specification
This machine is a Class 1 laser product as defined in IEC 60825-1
specifications. The label shown below is attached in countries where
required.
This machine has a Class 3B Laser Diode which emits invisible laser
radiation in the Scanner Unit. The Scanner Unit should not be opened under
any circumstances.
Laser Diode
Wave length: 770 - 810 nm
Output: 5 mW max.
Laser Class: Class 3B
Avertizare
Use of controls, adjustments or performance of procedures other than those
specified in this manual may result in hazardous radiation exposure.
Disconnect device
This product must be installed near an electrical socket that is easily
accessible. In case of emergencies, you must disconnect the power cord
from the electrical socket to shut off power completely.
Wiring information
Important
If you need to replace the plug fuse, fit a fuse that is approved by ASTA to
BS1362 with the same rating as the original fuse.
Always replace the fuse cover. Never use a plug that does not have a cover.
Warning - This printer must be earthed.
The wires in the mains lead are coloured in line with the following code:
Green and Yellow: Earth
Blue: Neutral
Brown: Live
If in any doubt, call a qualified electrician.
LAN connection (MFC-7820N only)
Atenţie
Do not connect this product to a LAN connection that is subject to over-
voltages.
Radio interference
This product complies with EN55022 (CISPR Publication 22)/Class B. Before
this product is used, ensure that you use the following interface cables.
1. A shielded parallel interface cable with twisted-pair conductors and that is
marked “IEEE 1284 compliant”. The cable must not exceed 2.0 metres in
length.
2. A USB cable. The cable must not exceed 2.0 metres in length.
International ENERGY STAR
®
Compliance Statement
The purpose of the International ENERGY STAR
®
Program is to promote the
development and popularization of energy-efficient office equipment.
As an E
NERGY STAR
®
Partner, Brother Industries, Ltd. has determined that
this product meets the ENERGY STAR
®
guidelines for energy efficiency.
Reglementări
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
LASER KLASSE 1 PRODUKT
Avertizare Atenţie
Avertizările ce trebuie respectate pentru
prevenirea leziunilor corporale.
Atenţionările specifică proceduri care
trebuie urmate pentru a preveni posibila
deteriorare a aparatului.
Setare neadecvată Observaţie Ghidul utilizatorului
Vă avertizează asupra dispozitivelor și
operaţiunilor care nu sunt compatibile
cu aparatul.
Indică observaţii și indicaţii folositoare
pentru utilizarea aparatului.
Indică referinţa la Ghidul utilizatorului.