User Manual

8 - 1
8
‘
Using the machine as a
copier
You can use your machine as a copier,
making up to 99 copies at a time.
Enter Copy mode
Before making copies, make sure that
(Copy) is illuminated in green. If it is
not, press (Copy) to enter Copy mode.
The default setting is Fax mode. You can
change the number of seconds or minutes
that the machine stays in Copy mode.
(See Setting the Mode Timer on page 2-4.)
The printable area of your machine begins at
approximately 2 mm from both sides and
3 mm from the top or bottom of the paper.
Note
This printable area shown above is for a
single copy or a 1 in 1 copy using A4 size
paper. The printable area changes with the
paper size.
Making a single copy
1
Press (Copy) to illuminate it in
green.
2
Load your document.
(See Load document on page 1-7.)
3
Press Start.
Making copies
Stack Copies:01
100%
 Auto
Copy Ratio
The LCD shows the default copy setting
Contrast
Quality
No. of Copies
Stack/Sort
2 mm
3 mm
Unprintable area