Owner's Manual

5 - 4

INITIAL SETUP

Setting Beeper Volume

You can set the beeper to LOW, HIGH or OFF. The default setting is LOW.

When the beeper is set to LOW or HIGH, the MFC beeps every time you press

a key or make an error, and at the end of fax sending or receiving.

Press Function, 1, 1, 3.

Press or to select your setting.

When the screen displays the setting you want, press Set.

Press Stop to exit.

Choosing the Handset Volume

Before you begin to use the machine, you must decide if you need to set the

handset volume to AMPLIFY:ON for a user who is hearing-impaired. The

AMPLIFY volume level complies with FCC standards.

VOLUME AMPLIFY: OFF

This default setting is appropriate if none of the users are hearing-impaired.

During a conversation, users can press Volume

or on the control panel

to adjust the volume to LOW or HIGH. When the handset is replaced, the

handset volume will remain until you change it again.

VOLUME AMPLIFY: ON—TEMPORARY

This setting is appropriate if some of the users are hearing-impaired. During a

conversation, users can press Volume

or on the control panel to adjust

the volume to LOW, HIGH or AMPLIFY. When the handset is replaced, the

handset volume returns to the default setting of LOW.

VOLUME AMPLIFY:ON—PERMANENT

Choose VOL AMPLIFY:ON—PERMANENT if all of the users are

hearing-impaired. During a conversation, users can press Volume

or on

the control panel to adjust the volume to LOW, HIGH or AMPLIFY. When the

handset is replaced, the handset volume returns to the default setting of

AMPLIFY.

WARNING

It is important that you do not choose PERMANENT unless all the users

are hearing-impaired. Otherwise, the default setting of AMPLIFY may

damage the hearing of some users.

When you press Volume or on the control panel to adjust the volume,

the display shows the setting you are choosing. Each key press changes the

volume to the next setting.