User Manual
Table Of Contents
- Quick Setup Guide MFC-640CW
- Table of Contents
- Getting Started
- STEP1 Setting Up the Machine
- 1 Removing the protective parts
- 2 Installing the handset
- 3 Loading paper
- 4 Installing the phone line and power cord
- 5 Set Your Country (For Australia / New Zealand Customer Only)
- 6 Installing the ink cartridges
- 7 Print quality check
- 8 Setting the date and time
- 9 Setting your station ID
- 10 Choosing a Receive Mode
- 11 Setting up the TAD
- STEP2 Installing the Driver & Software
- For Network Users
- Consumables and Options
- brother ARL/ASA/NZ
For Network Users
40
How to set the machine’s
network settings to wireless
LAN or wired LAN
To connect your Brother machine to a wireless or
wired network you must configure the machine from
the machine’s control panel for the network type you
are using.
For wireless LAN
On your machine, press Menu/Set, 5, 6 then press a
or b to choose WLAN, and then press Menu/Set.
Press 1 1.Yes to reboot the machine. The wired
network interface will become inactive with this
setting.
It will take about a minute for the LAN menu on the
LCD to become available again.
For wired LAN
On your machine, press Menu/Set, 5, 6 then press a
or b to choose Wired LAN, and then press
Menu/Set. Press 1 1.Yes to reboot the machine. The
wireless network interface will become inactive with
this setting.
It will take about a minute for the LAN menu on the
LCD to become available again.