Owner manual
Table Of Contents
- SOFTWARE USER’S GUIDE
- Table of Contents
- Section I Windows®
- 1 Printing
- 2 Scanning
- Scanning a document using the TWAIN driver
- Scanning a document using the WIA driver (For Windows® XP only)
- Using the Scan key (For USB cable users)
- Using ScanSoft® PaperPort® 9.0SE and OmniPage® OCR
- 3 ControlCenter2
- 4 Network Scanning (For models with built-in network support)
- 5 Remote Setup (Not available for DCP models)
- 6 Brother PC-FAX Software (For MFC models only)
- PC-FAX sending
- Speed Dial setup
- Brother Address Book
- Setting up a member in the Address Book
- Setting up a group for broadcasting
- Editing member information
- Deleting a member or group
- Exporting the Address Book
- Importing to the Address Book
- Setting up a cover page
- Entering cover page information
- Sending a file as a PC-FAX using the Facsimile style user interface
- Sending a file as a PC-FAX using the Simple style user interface
- PC-FAX receiving (MFC-640CW and MFC-820CW only)
- 7 PhotoCapture Center™
- Section II Apple® Macintosh®
- 8 Printing and Faxing
- 9 Scanning
- 10 ControlCenter2
- 11 Network Scanning (For models with built-in network support)
- 12 Remote Setup & PhotoCapture Center™
- Index
- brother USA
Network Scanning (For models with built-in network support)
72
Using the Scan key 4
Note
If you use the Scan key on USB, see Using the Scan key (For USB cable users) on page 35.
Scan to E-mail (PC) 4
When you choose Scan to E-mail (PC) your document will be scanned and sent directly to the PC you
designated on your network. The ControlCenter2 software will launch the default E-mail application on the
designated PC. You can scan and send a black and white or color document from the PC as an attachment.
You can change the (Scan) configuration. (See E-mail on page 53.)
a Load your document.
b Press the (Scan) key.
c Press a or b to choose Scan to E-mail.
Press Menu/Set, Set or OK.
d Press a or b to choose the destination PC you want to use for E-mailing your document.
Press Menu/Set, Set or OK.
If the LCD prompts you to enter a PIN number, enter the 4-digit PIN number for the destination PC on
the control panel.
Press Menu/Set, Set or OK.
e Press Black Start or Color Start.
The machine starts the scanning process.