User`s guide

Control panel setup
4 - 7
4
5.Node Name
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
BRN_xxxxxx for a wired network or BRW_xxxxxx for a wireless network (where xxxxxx is the last six digits of
the Ethernet address) (up to 15 characters).
(For MFC-640CW)
1 (For Wired) Press Menu/Set, 5, 1, 5.
(For Wireless) Press Menu/Set, 5, 2, 5.
2 Select 1 to change. Enter the Node Name.
3 Press Menu/Set.
4 Press Stop/Exit.
(For MFC-820CW)
1 Press Menu.
2 Press ▲ or ▼ to select LAN.
Press OK.
3 (For Wired) Press ▲ or ▼ to select TCP/IP(Wired).
(For Wireless) Press ▲ or ▼ to select TCP/IP(WLAN)
Press OK.
4 Press ▲ or ▼ to select Node Name.
Press OK.
5 Press ▲ or ▼ to select Change.
Press OK.
6 Enter the Node Name.
Press OK.
7 Press Stop/Exit.