Network User's Guide
Table Of Contents
- IMPORTANT INFORMATION: REGULATIONS
- Table of Contents
- 1. Introduction
- 2. TCP/IP Configuration
- 3. Front Panel Setup
- 4. Network Printing from Windows® (Peer to Peer)
- 5. Network Printing from Macintosh®
- 6. Troubleshooting
- 7. Brother Internet Fax Printing Software
- Appendix
- INDEX
3 - 12 FRONT PANEL SETUP
NC9100h_FM6.0
Restoring the Network Settings to Factory Default
To restore all network settings of the internal Print/Scan server to
factory default, please follow the steps below.
1
Make sure the machine is not operating, then disconnect all the
cables from the machine (except power cable).
2
Press Menu/Set, 5, 0. (4, 0 for MFC-5440CN)
3
Press 1 to select Reset.
4
Press 1 to select Yes.
5
The machine will re-start, re-connect cables once this is
complete.