Network User's Guide
Table Of Contents
- IMPORTANT INFORMATION: REGULATIONS
- Table of Contents
- 1. Introduction
- 2. TCP/IP Configuration
- 3. Front Panel Setup
- 4. Network Printing from Windows® (Peer to Peer)
- 5. Network Printing from Macintosh®
- 6. Troubleshooting
- 7. Brother Internet Fax Printing Software
- Appendix
- INDEX
FRONT PANEL SETUP 3 - 7
NC9100h_FM6.0
Host Name
You can register the machine name on the Network. This name is
often referred to as a NetBIOS name; it will be the name that is
registered by the WINS server on your network. Brother
recommends the name BRN_XXXXXX (where XXXXXX is the last
six digits of the Ethernet address) (up to 15 characters).
1
Press Menu/Set, 5, 1, 5. (4, 1, 5 for MFC-5440CN)
2
Select 1 to change. Enter the Host Name.
3
Press Menu/Set.
4
Press Stop/Exit.
WINS Config
This selection controls how the machine obtains the IP address for
the WINS server.
1
Press Menu/Set, 5, 1, 6. (4, 1, 6 for MFC-5440CN)
2
Press ▲ or ▼ to select Auto or Static.
3
Press Menu/Set.
4
Press Stop/Exit.
Auto
Automatically uses a DHCP request to determine the IP addresses
for the primary and secondary WINS servers. You must set the
BOOT Method to Auto for this feature to work.
Static
Uses a specified IP address for the primary and secondary WINS
servers.