User Manual

144
Dial Tone detection B
When you send a fax automatically, by
default your machine will wait for a fixed
amount of time before it starts to dial the
number. By changing the Dial Tone setting to
Detection you can make your machine dial
as soon as it detects a dial tone. This setting
can save a small amount of time when
sending a fax to many different numbers. If
you change the setting and start having
problems with dialling you should change
back to the factory No Detection setting.
a Press Menu.
b Press a or b to choose
Initial Setup.
Press OK.
c Press a or b to choose Dial Tone.
d Press d or c to choose Detection or
No Detection.
Press OK.
e Press Stop/Exit.
Telephone line interference B
If you are having problems sending or
receiving a fax due to possible interference
on the telephone line, you can change the
compatibility setting, which reduces the
modem speed to minimise errors.
a Press Menu.
b Press a or b to choose Fax.
Press OK.
c Press a or b to choose
Miscellaneous .
Press OK.
d Press a or b to choose
Compatibility .
e Press d or c to choose High, Normal or
Basic(for VoIP).
 Basic(for VoIP) cuts the
modem speed to 9600 bps. Unless
interference is a recurring problem
on your telephone line, you may
prefer to use it only when needed.
 Normal sets the modem speed at
14400 bps.
 High increases the modem speed to
33600 bps. (factory setting)
Press OK.
f Press Stop/Exit.
Note
When you change the compatibility to
Basic(for VoIP), the ECM feature is
only available for color fax sending.