User Manual

Chapter 11
96
Using a scanned paper document as
your watermark
11
a Press (Copy).
b Enter the number of copies you want.
c Press a or b to choose
Watermark Copy.
Press OK.
d Press d or c to choose On.
e Press a or b to choose
Current Setting.
Press OK.
f Press a or b to choose Scan. Press OK,
and place the page that you want to use
as a watermark on the scanner glass.
g Press Mono Start or Color Start.
h Take out the watermark document you
scanned and load the document you
want to copy.
i Press d or c to change the
Transparency of the watermark.
Press OK.
j Press Mono Start or Color Start.
Note
You cannot enlarge or reduce the
scanned watermark.
Setting your changes as a
new default 11
You can save the copy settings for Quality,
Enlarge/Reduce, Tray Select (MFC-
6490CW only), Brightness, Contrast,
Page Layout or Skew Adjustment
(MFC-6490CW only) that you use most often
by setting them as the default settings. These
settings will stay until you change them again.
a Press (Copy).
b Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
c After changing the last setting, press
a or b to choose Set New Default.
Press OK.
d Press 1 to choose Yes.
e Press Stop/Exit.
Restoring all settings to the
factory settings 11
You can restore all the settings you have
changed back to the factory settings. These
settings will stay until you change them again.
a Press (Copy).
b Press a or b to choose
Factory Reset.
Press OK.
c Press 1 to choose Yes.
d Press Stop/Exit.