Network User's Guide for Internet Fax
Table Of Contents
- Internet FAX User’s Guide
- Table of Contents
- 1 Control Panel Setup
- 2 Internet FAX
- 3 Configuring Internet Printing for Windows®
- Internet Printing Installation
- Overview
- Brother Internet Print General Information
- Brother Internet Print Configuring the Brother Print/Fax Server
- Brother Internet Print Using BRAdmin Professional utility to Configure the Print Server
- Brother Internet Print Installing the BIP software on Windows® 98/Me/2000/XP
- Adding a Second Brother Internet Port
- Other Sources of Information
- Internet Printing Installation
- INDEX
CONTROL PANEL SETUP 1 - 16
NC9100h_FM6.0
Setup Mail TX (Transmit)
This menu has three selections: Sender Subject, Size Limit and
Notification.
Sender Subject
This field displays the subject that is attached to the Internet Fax data
being sent from the Brother machine to a PC (default is “Internet
Fax Job”).
1
Press Menu/Set, 5, 4, 1 for MFC-3340CN/MFC-5840CN. (4,
4, 1 for FAX-1940CN/MFC-5440CN)
2
Select 1 to change the Sender Subject—OR—2 to exit.
3
Enter the subject information (up to 40 characters).
4
Press Menu/Set.
5
Press Stop/Exit.
Size Limit
Some E-mail servers do not allow you to send large E-mail
documents. The machine may display Out of Memory when trying
to send E-mail documents (the System Administrator will often place
a limit on the maximum E-mail size). With this function enabled, the
machine will display Out of Memory when trying to send E-mail
documents over 1Mbyte in size. The document will not be sent and
an error report will be printed. The document you are sending should
be separated into smaller documents that will be accepted by the
mail server (default is Off). (Ex. A 42 page document of the ITU-T
Test Chart#1 test chart is approximately 1Mbyte in size).
1
Press Menu/Set, 5, 4, 2 for MFC-3340CN/MFC-5840CN. (4,
4, 2 for FAX-1940CN/MFC-5440CN)
2
Press ▲ or ▼ to select On or Off.
3
Press Menu/Set.
4
Press Stop/Exit.