User Manual

3 - 20 FRONT PANEL SETUP
NC9100h_FM6.0
Restoring the Network Settings to Factory Default
To restore all network settings of the internal Print/Scan server to
factory default, please follow the steps below.
(For MFC-410CN, MFC-620CN, MFC-3340CN, MFC-5440CN,
MFC-5840CN)
1 Make sure the machine is not operating, then disconnect all the
cables from the machine (except power cable).
2 Press Menu/Set, 5, 0. (4, 0 for MFC-5440CN)
3 Press 1 to select Reset.
4 Press 1 to select Yes.
5 The machine will re-start, re-connect cables once this is
complete.
(For DCP-310CN)
1 Make sure the machine is not operating, then disconnect all the
cables from the machine (except power cable).
2 Press Menu.
3 Press ▲ or ▼ to select 3.LAN.
Press Set.
4 Press ▲ or ▼ to select 0.Factory Reset.
Press Set.
5 Press ▲ to select 1.Reset.
6 Press ▲ again to select 1.Yes.
7 The machine will re-start, re-connect cables once this is
complete.