User Manual
Table Of Contents
- USER’S GUIDE MFC-5440CN/MFC-5840CN
- Brother numbers
- Ordering accessories and supplies
- Safety precautions
- Choosing a location
- Quick Reference Guide
- Table of Contents
- 1 Introduction
- 2 Getting started
- Initial Setup
- General Setup
- Setting the Mode Timer
- Setting the Paper Type
- Setting the Paper Size
- Setting the Ring Volume
- Setting the Beeper Volume
- Setting the Speaker Volume
- Turning on Automatic Daylight Savings Time
- Setting the LCD Contrast
- Setting the Tray Use for Copy mode (MFC-5840CN only)
- Setting the Tray Use for Fax mode (MFC-5840CN only)
- 3 Setup Send
- 4 Setup Receive
- 5 Quick-Dial numbers and dialing options
- 6 Remote Fax Options (Not available for color faxes)
- 7 Printing reports
- 8 Making copies
- 9 Walk-Up PhotoCapture Center™ (MFC-5840CN only)
- 10 Important information
- 11 Troubleshooting and routine maintenance
- Appendix A
- Appendix B
- Glossary
- Specifications
- Index
- Remote Retrieval Access card
- brother USA/CAN
8 - 7 MAKING COPIES
Using the Tray Select key (MFC-5840CN only)
The MFC uses the paper in Tray#1 first. You can change the tray that
will be used for next copy only.
1
Press (
Copy
) to illuminate it in green.
2
Load your document.
3
Use the dial pad to enter the number of copies you want
(up to 99).
4
Press
Tray Select
.
5
Press
▲
or
▼
to select
Auto
,
#1(xxx)
or
#2(xxx)
.
Press
Menu/Set
.
6
Press
Black Start
or
Color Start
.
■
If both trays are using paper that is the same type and size,
Auto
will allow your MFC to take paper from Tray#2 if
Tray#1 is out of paper.
■
You can only use plain paper sizes Letter, Legal or A4 in
Tray#2.