User Manual
Table Of Contents
- USER’S GUIDE MFC-5440CN/MFC-5840CN
- Brother numbers
- Ordering accessories and supplies
- Safety precautions
- Choosing a location
- Quick Reference Guide
- Table of Contents
- 1 Introduction
- 2 Getting started
- Initial Setup
- General Setup
- Setting the Mode Timer
- Setting the Paper Type
- Setting the Paper Size
- Setting the Ring Volume
- Setting the Beeper Volume
- Setting the Speaker Volume
- Turning on Automatic Daylight Savings Time
- Setting the LCD Contrast
- Setting the Tray Use for Copy mode (MFC-5840CN only)
- Setting the Tray Use for Fax mode (MFC-5840CN only)
- 3 Setup Send
- 4 Setup Receive
- 5 Quick-Dial numbers and dialing options
- 6 Remote Fax Options (Not available for color faxes)
- 7 Printing reports
- 8 Making copies
- 9 Walk-Up PhotoCapture Center™ (MFC-5840CN only)
- 10 Important information
- 11 Troubleshooting and routine maintenance
- Appendix A
- Appendix B
- Glossary
- Specifications
- Index
- Remote Retrieval Access card
- brother USA/CAN
8 - 3 MAKING COPIES
Using the temporary Copy keys
When you want to quickly change the copy settings temporarily for
the next copy, use the temporary Copy keys. You can use different
combinations.
These settings are temporary, and the MFC returns to its default
settings 60 seconds after it finishes copying. However if you
have set the Mode Timer to 0 or 30 seconds, the MFC returns
to the default settings after the number of seconds that has been
set for mode timer. (See Setting the Mode Timer on page 2-3.)
You can save the copy settings you use most often by setting
them as default. (See Changing the default copy settings on
page 8-16.)
Temporary Copy keys
(For MFC-5440CN)
Temporary Copy keys
(For MFC-5840CN)