User Manual
Table Of Contents
- USER’S GUIDE MFC-5440CN/MFC-5840CN
- Brother numbers
- Ordering accessories and supplies
- Safety precautions
- Choosing a location
- Quick Reference Guide
- Table of Contents
- 1 Introduction
- 2 Getting started
- Initial Setup
- General Setup
- Setting the Mode Timer
- Setting the Paper Type
- Setting the Paper Size
- Setting the Ring Volume
- Setting the Beeper Volume
- Setting the Speaker Volume
- Turning on Automatic Daylight Savings Time
- Setting the LCD Contrast
- Setting the Tray Use for Copy mode (MFC-5840CN only)
- Setting the Tray Use for Fax mode (MFC-5840CN only)
- 3 Setup Send
- 4 Setup Receive
- 5 Quick-Dial numbers and dialing options
- 6 Remote Fax Options (Not available for color faxes)
- 7 Printing reports
- 8 Making copies
- 9 Walk-Up PhotoCapture Center™ (MFC-5840CN only)
- 10 Important information
- 11 Troubleshooting and routine maintenance
- Appendix A
- Appendix B
- Glossary
- Specifications
- Index
- Remote Retrieval Access card
- brother USA/CAN
QUICK-DIAL NUMBERS AND DIALING OPTIONS 5 - 2
Changing Speed-Dial numbers
If you try to store a Speed-Dial number where a number has already
been stored, the LCD will show the name that has been stored there
(or number) and will ask you to do one of the following:
1
Press
1
to change the stored number.
—OR—
Press
2
to exit without making a change.
How to change the stored number or name:
■
If you want to change a character, use or to position
the cursor under the character you want to change, and then
type over it.
■
If you want to erase the whole number or whole name, press
Stop/Exit
when the cursor is under the first digit or letter.
The characters above and to the right of the cursor will be
deleted.
2
Enter a new number.
Press
Menu/Set
.
3
Follow the directions beginning at Step 4 in Storing Speed-Dial
numbers. (See page 5-1.)
▲
▲