User Manual
Table Of Contents
- USER’S GUIDE MFC-5440CN/MFC-5840CN
- Brother numbers
- Ordering accessories and supplies
- Safety precautions
- Choosing a location
- Quick Reference Guide
- Table of Contents
- 1 Introduction
- 2 Getting started
- Initial Setup
- General Setup
- Setting the Mode Timer
- Setting the Paper Type
- Setting the Paper Size
- Setting the Ring Volume
- Setting the Beeper Volume
- Setting the Speaker Volume
- Turning on Automatic Daylight Savings Time
- Setting the LCD Contrast
- Setting the Tray Use for Copy mode (MFC-5840CN only)
- Setting the Tray Use for Fax mode (MFC-5840CN only)
- 3 Setup Send
- 4 Setup Receive
- 5 Quick-Dial numbers and dialing options
- 6 Remote Fax Options (Not available for color faxes)
- 7 Printing reports
- 8 Making copies
- 9 Walk-Up PhotoCapture Center™ (MFC-5840CN only)
- 10 Important information
- 11 Troubleshooting and routine maintenance
- Appendix A
- Appendix B
- Glossary
- Specifications
- Index
- Remote Retrieval Access card
- brother USA/CAN
GETTING STARTED 2 - 5
Setting the Ring Volume
You can turn the ring
Off
or you can select the ring volume level.
1
Press
Menu/Set
,
1
,
4
,
1
.
2
Press
▲
or
▼
to select
Low
,
Med
,
High
or
Off
.
Press
Menu/Set
.
3
Press
Stop/Exit
.
—OR—
You can adjust the ring volume when your MFC is idle (not being
used). In Fax mode , press or to adjust the volume
level. Every time you press these keys, the MFC will ring so you can
hear the active setting as the LCD shows it. The volume changes
with each key press. The new setting will stay until you change it
again.
Setting the Beeper Volume
You can change the beeper volume. The default (factory) setting is
Low
. When the beeper is on, the MFC will beep when you press a
key, make a mistake and whenever you send or received a fax.
1
Press
Menu/Set
,
1
,
4
,
2
.
2
Press
▲
or
▼
to select your option.
(
Low
,
Med
,
High
or
Off
)
Press
Menu/Set
.
3
Press
Stop/Exit
.
Volume
1.Ring
Volume
2.Beeper