User Manual
Table Of Contents
- USER’S GUIDE MFC-5440CN/MFC-5840CN
- Brother numbers
- Ordering accessories and supplies
- Safety precautions
- Choosing a location
- Quick Reference Guide
- Table of Contents
- 1 Introduction
- 2 Getting started
- Initial Setup
- General Setup
- Setting the Mode Timer
- Setting the Paper Type
- Setting the Paper Size
- Setting the Ring Volume
- Setting the Beeper Volume
- Setting the Speaker Volume
- Turning on Automatic Daylight Savings Time
- Setting the LCD Contrast
- Setting the Tray Use for Copy mode (MFC-5840CN only)
- Setting the Tray Use for Fax mode (MFC-5840CN only)
- 3 Setup Send
- 4 Setup Receive
- 5 Quick-Dial numbers and dialing options
- 6 Remote Fax Options (Not available for color faxes)
- 7 Printing reports
- 8 Making copies
- 9 Walk-Up PhotoCapture Center™ (MFC-5840CN only)
- 10 Important information
- 11 Troubleshooting and routine maintenance
- Appendix A
- Appendix B
- Glossary
- Specifications
- Index
- Remote Retrieval Access card
- brother USA/CAN
11 - 27 TROUBLESHOOTING AND ROUTINE MAINTENANCE
7
If you replaced an ink cartridge while
Near Empty
was
displayed on the LCD, the LCD may ask you to verify that it was
a brand new one. Example:
Did You Change
Blck? 1.Yes
2.No
. For each
new
cartridge you installed, press
1
on the dial
pad to automatically reset the ink dot counter for that color. If the
ink cartridge you installed is not a brand new one, please be
sure to select
2
.
WARNI NG
If ink gets in your eyes, irrigate them with water immediately and call
a doctor if you are concerned.
If you wait until
Ink Empty
message is displayed on the LCD,
the MFC will automatically reset the ink dot counter.
If the
Install
message is on the display after you have
installed ink cartridges, check that the ink cartridges are
installed properly.